OneCycleLR¶
- class mmengine.optim.OneCycleLR(optimizer, *args, **kwargs)[source]¶
Sets the learning rate of each parameter group according to the 1cycle learning rate policy. The 1cycle policy anneals the learning rate from an initial learning rate to some maximum learning rate and then from that maximum learning rate to some minimum learning rate much lower than the initial learning rate. This policy was initially described in the paper Super-Convergence: Very Fast Training of Neural Networks Using Large Learning Rates.
The 1cycle learning rate policy changes the learning rate after every batch. step should be called after a batch has been used for training.
This scheduler is not chainable.
Note also that the total number of steps in the cycle can be determined in one of two ways (listed in order of precedence):
A value for total_steps is explicitly provided.
A number of epochs (epochs) and a number of steps per epoch (steps_per_epoch) are provided. In this case, the number of total steps is inferred by total_steps = epochs * steps_per_epoch
You must either provide a value for total_steps or provide a value for both epochs and steps_per_epoch.
The default behaviour of this scheduler follows the fastai implementation of 1cycle, which claims that “unpublished work has shown even better results by using only two phases”. To mimic the behaviour of the original paper instead, set
three_phase=True
.- Parameters
optimizer (Optimizer) – Wrapped optimizer.
eta_max (float or list) – Upper parameter value boundaries in the cycle for each parameter group.
total_steps (int) – The total number of steps in the cycle. Note that if a value is not provided here, then it must be inferred by providing a value for epochs and steps_per_epoch. Default to None.
pct_start (float) – The percentage of the cycle (in number of steps) spent increasing the learning rate. Default to 0.3
anneal_strategy (str) – {‘cos’, ‘linear’} Specifies the annealing strategy: “cos” for cosine annealing, “linear” for linear annealing. Default to ‘cos’
div_factor (float) – Determines the initial learning rate via initial_param = eta_max/div_factor Default to 25
final_div_factor (float) – Determines the minimum learning rate via eta_min = initial_param/final_div_factor Default to 1e4
three_phase (bool) – If
True
, use a third phase of the schedule to annihilate the learning rate according to ‘final_div_factor’ instead of modifying the second phase (the first two phases will be symmetrical about the step indicated by ‘pct_start’).last_step (int) – The index of last step. Used for resume without state dict. Defaults to -1.
by_epoch (bool) – Whether the scheduled parameters are updated by epochs. Defaults to True.
verbose (bool) – Whether to print the value for each update. Defaults to False.